Workspace Structure Before inserting components and wires to your project, it’s necessary to understand a little of the workspace structure. This will...
Inserting Wires (First Method) Inserting phase and neutral… Double click on the page 03- COMANDO DIRETA to start Select the red wire with...
Inserting components Inserting the first component… In the Component palette Open the folder BOTÕES > TELEMECANIQUE > HARMONY XB5 >...
Adding Contacts to a Component For the insertion of contacts into your projects, you need to utilise the “Custom” or “Project” palette. Inside “Custom” you...
Linking Accessories This article will teach you how to link accessories to any given component. When working on a project, you might...
Inserting Wires (Second Method) To initiate your strength part, you will need 4 power wires (triple-phase and protection). However, as you’ve read in the...
Inserting Terminals and Engines This article goes over the steps for the insertion of terminals and engines.
Designing a reverse start In this article, you should apply the knowledge acquired in previous sections to design a reverse start by yourself. Therefore, we...
Tips for designing a reverse start (Part 1) Is there any easier way to design a reverse start? To facilitate the project development of a reverse start, we...
Tips for designing a reverse start (Part 2) TIP 5: Reverse the phases in the reversing start This tip is for those who are already finishing the exercise....