1. Home
  2. Organização do projeto
  3. Wires project numbering reset

Wires project numbering reset

Updated on November 4, 2019
Apply to: 2016 R1, 2016 R2

The article will orient a reset all wire number (tags) of a project.

Wires numbering reset…

1. Open the project.
2.In interface Ribbon, on the tab “Draw”, select option “Find” like Figure A or in interface Classic, on menu “Edit”, select the option “Find” like Figure B.


You can use the shortcut:
“Ctrl + F”
Without the quotes.

3. Click on “Find…”, the popup “Find and replace” will open.

4. Click on “Advanced”, on bottom left icon of the popup “Find and replace”. When you click “Advanced”, the popup below will open:

5. The popup “Advanced” must be configured , like Figure C. After realized this configuration, click on “OK” and automatically will close and go back to “Find and replace” popup, click on “Find”

6. When click on “Replace” the name/number of all wires will is removed. When access “Project” pallet, you notice that the wires name/numbers are removed

Was this article helpful?

Related Articles